Element 3 Question 3-18B2
C3B18: Calculations
A 1-watt, 10-volt Zener diode with the following characteristics: Imin. = 5 mA; Imax. = 95 mA; and Z = 8 ohms, is to be used as part of a voltage regulator in a 20-V power supply. Approximately what size current-limiting resistor would be used to set its bias to the midpoint of its operating range?
- 100 ohms.
- 200 ohms. (correct answer)
- 1 kilohms.
- 2 kilohms.
Correct answer: B, 200 ohms.
Explanation
The midpoint of the operating range is (5 mA + 95 mA) / 2 = 50 mA. The series resistor drops the difference between supply and Zener voltage: 20 V − 10 V = 10 V. So R = V / I = 10 V / 0.05 A = 200 Ω. The 8 Ω Zener impedance is small enough to ignore at this level of approximation.
Why the other answers are wrong
- A, 100 ohms.: 100 Ω passes 10 V / 100 Ω = 100 mA. That exceeds the 95 mA maximum and reaches the 1 W limit (1 W / 10 V).
- C, 1 kilohms.: 1 kΩ passes only 10 V / 1 kΩ = 10 mA. That sits near the bottom of the range, not at the 50 mA midpoint.
- D, 2 kilohms.: 2 kΩ passes only 5 mA, which is right at the minimum. Any load current would starve the Zener out of regulation.