Element 3 Question 3-32D6
C3D32: Schematics
With a pure AC signal input to the circuit shown in Figure 3D11, what output wave form would you expect to see on an oscilloscope display?
- 1
- 2 (correct answer)
- 3
- 4
Correct answer: B, 2
Explanation
The diode is a shunt clipper, with its anode on the output line and its cathode on the return line. On positive half-cycles the diode is forward biased and conducts once the voltage reaches about +0.6 V, so the top of the wave is clipped flat while the series resistor drops the rest. On negative half-cycles the diode is reverse biased and acts as an open circuit, so the full negative swing reaches the output. That is waveform 2.
Why the other answers are wrong
- A, 1: Waveform 1 is the unchanged sine wave, which would only appear if the diode never conducted. A shunt diode clips the half-cycle that forward-biases it.
- C, 3: Waveform 3 has the negative half clipped. That would need the diode reversed, with its cathode on the output line, so that negative peaks forward-bias it.
- D, 4: Waveform 4 is clipped on both halves. That needs two diodes connected back to back in opposite directions, not the single diode shown.