Element 3 Question 3-50F2
C3F50: Receiver Performance
How can ferrite beads be used to suppress ignition noise? Install them:
- In the resistive high voltage cable every 2 years.
- Between the starter solenoid and the starter motor.
- Install them in the primary and secondary ignition leads. (correct answer)
- In the antenna lead.
Correct answer: C, Install them in the primary and secondary ignition leads.
Explanation
Ignition noise comes from fast spark pulses whose RF energy radiates from the wiring. A ferrite bead slipped over a conductor adds series impedance that rises with frequency and soaks up RF as heat, while DC and low-frequency current pass almost unaffected. Beads on the primary (coil feed) and secondary (high-voltage) ignition leads suppress the noise at its source, before it radiates.
Why the other answers are wrong
- A, In the resistive high voltage cable every 2 years.: Ferrite beads aren't a scheduled maintenance item, and resistive high-voltage cable is itself a suppression device. This mixes up two separate methods.
- B, Between the starter solenoid and the starter motor.: The starter motor runs only briefly while cranking. Its circuit isn't the source of the continuous ignition noise heard while the engine runs.
- D, In the antenna lead.: Ignition noise should be stopped at its source. A bead on the antenna lead doesn't touch the spark wiring that is radiating the noise.