Element 3 Question 3-52G2
C3G52: Amplifiers-2
What input-amplitude parameter is most valuable in evaluating the signal-handling capability of a Class A amplifier?
- Average voltage.
- RMS voltage.
- Peak voltage. (correct answer)
- Resting voltage.
Correct answer: C, Peak voltage.
Explanation
A Class A amplifier stays linear only while the input swing keeps the active device between cutoff and saturation. Distortion starts the moment the waveform's highest excursion crosses either limit. That makes the peak input voltage, not an average or RMS figure, the measure of whether the stage can handle a signal without clipping.
Why the other answers are wrong
- A, Average voltage.: The average of a symmetrical AC signal is near zero over a full cycle, so it says nothing about how far the instantaneous swing reaches toward cutoff or saturation.
- B, RMS voltage.: RMS voltage describes the power or heating effect. Two waveforms with equal RMS can have very different peaks, and the peaks drive the stage into clipping.
- D, Resting voltage.: Resting (quiescent) voltage is the no-signal bias point. It sets where the swing is centered but is not a property of the input signal.