Element 3 Question 3-59H4
C3H59: Pulse Modulation
Which of the following best describes a pulse modulation system?
- The peak transmitter power is normally much greater than the average power. (correct answer)
- Pulse modulation is sometimes used in SSB voice transmitters.
- The average power is normally only slightly below the peak power.
- The peak power is normally twice as high as the average power.
Correct answer: A, The peak transmitter power is normally much greater than the average power.
Explanation
A pulse transmitter is on for only a small fraction of each cycle (a low duty cycle) and idle the rest of the time. Average power = peak power × duty cycle. A radar sending 1 µs pulses 1000 times per second has a duty cycle of 0.001, so a 100 kW peak averages only 100 W. Peak power is therefore normally far greater than average power.
Why the other answers are wrong
- B, Pulse modulation is sometimes used in SSB voice transmitters.: SSB voice is an analog amplitude-modulation method with a suppressed carrier, not a pulsed one, so pulse modulation is not the technique it uses.
- C, The average power is normally only slightly below the peak power.: An average power close to peak requires a duty cycle near 100%. That describes continuous-wave or FM operation, not short pulses.
- D, The peak power is normally twice as high as the average power.: Peak power equal to twice the average means a 50% duty cycle. Pulse systems such as radar normally run duty cycles far below that.