Element 3 Question 3-66J3
C3J66: Transmission Lines
Nitrogen is placed in transmission lines to:
- Improve the “skin-effect” of microwaves.
- Reduce arcing in the line.
- Reduce the standing wave ratio of the line.
- Prevent moisture from entering the line. (correct answer)
Correct answer: D, Prevent moisture from entering the line.
Explanation
Air-dielectric coax and waveguide are filled with dry nitrogen under slight positive pressure. Because the pressure is higher inside, any small leak pushes gas out instead of letting humid air in. Moisture inside a line raises dielectric loss, corrodes the conductors and changes the impedance. Nitrogen is used because it is dry, inert and cheap.
Why the other answers are wrong
- A, Improve the “skin-effect” of microwaves.: Skin effect depends on frequency and conductor properties. Filling the line with gas doesn't improve or change it.
- B, Reduce arcing in the line.: Dry, pressurized gas may slightly raise breakdown voltage, but the main purpose of nitrogen is to keep moisture out.
- C, Reduce the standing wave ratio of the line.: SWR is set by how well the load matches the line's impedance. Nitrogen does nothing to correct a mismatch.