Element 3 Question 3-70K5
C3K70: Instrument Landing System (ILS)
Choose the only correct statement about the localizer beam system used by aircraft to find the centerline of a runway during an Instrument Landing System (ILS) approach to an airport. The localizer beam system:
- Operates within the assigned frequency range of 108.10 to 111.95 GHz.
- Produces two amplitude modulated antenna patterns; one pattern above and one pattern below the normal 2.5 degree approach glide path of the aircraft.
- Frequencies are automatically tuned-in when the proper glide slope frequency is selected on the aircraft’s Navigation and Communication (NAV/COMM) transceiver.
- Produces two amplitude modulated antenna patterns; one pattern with an audio frequency of 90 Hz and one pattern with an audio frequency of 150 Hz, one left of the runway centerline and one right of the runway centerline. (correct answer)
Correct answer: D, Produces two amplitude modulated antenna patterns; one pattern with an audio frequency of 90 Hz and one pattern with an audio frequency of 150 Hz, one left of the runway centerline and one right of the runway centerline.
Explanation
The localizer is a VHF transmitter beyond the far end of the runway. It sends out two overlapping AM lobes. Seen from the approaching aircraft, the lobe on the left of the centerline is modulated at 90 Hz and the one on the right at 150 Hz. The receiver compares how strong the two tones are. Equal strength means the aircraft is on the centerline; otherwise the needle shows which way to steer.
Why the other answers are wrong
- A, Operates within the assigned frequency range of 108.10 to 111.95 GHz.: Localizer channels run from 108.10 to 111.95 MHz in the VHF band. The numbers are right but the unit is wrong: GHz is 1000 times too high.
- B, Produces two amplitude modulated antenna patterns; one pattern above and one pattern below the normal 2.5 degree approach glide path of the aircraft.: This describes the glide slope. It puts its 90 Hz and 150 Hz lobes above and below the descent path (about 3°) to give vertical guidance, not left/right guidance.
- C, Frequencies are automatically tuned-in when the proper glide slope frequency is selected on the aircraft’s Navigation and Communication (NAV/COMM) transceiver.: This has it backwards. Glide slope frequencies are paired with localizer channels, so selecting the localizer frequency on the NAV receiver tunes the matching glide slope automatically.