Element 3 Question 3-73K4
C3K73: Equipment Functions
Before ground testing an aircraft RADAR, the operator should:
- Ensure that the area in front of the antenna is clear of other maintenance personnel to avoid radiation hazards. (correct answer)
- Be sure the receiver has been properly shielded and grounded.
- First test the transmitter connected to a matched load.
- Measure power supply voltages to prevent circuit damage.
Correct answer: A, Ensure that the area in front of the antenna is clear of other maintenance personnel to avoid radiation hazards.
Explanation
A weather radar antenna puts out high-power microwave pulses that can harm the eyes and other tissue at close range. Before you transmit on the ground, clear people from the area in front of the antenna (the forward sector it sweeps) and keep them out of the minimum safe distance. Also make sure the beam isn't aimed at fuel, other aircraft or reflecting structures. Personnel safety comes before any equipment check.
Why the other answers are wrong
- B, Be sure the receiver has been properly shielded and grounded.: Shielding and grounding the receiver is a construction or installation matter. It does nothing to protect people from the radiated beam.
- C, First test the transmitter connected to a matched load.: A dummy load is a valid way to bench-test a transmitter, but the question is about ground-testing the installed radar, where the main concern is people near the antenna.
- D, Measure power supply voltages to prevent circuit damage.: Checking supply voltages is normal troubleshooting, but it isn't the key precaution. The danger in a ground test is RF exposure in front of the antenna.