Element 3 Question 3-79L2
C3L79: Repair Procedures
Which of the following is the preferred method of cleaning solder from plated-through circuit-board holes?
- Use a dental pick.
- Use a vacuum device. (correct answer)
- Use a soldering iron tip that has a temperature above 900 degrees F.
- Use an air jet device.
Correct answer: B, Use a vacuum device.
Explanation
A vacuum desoldering tool removes solder by suction. Examples are a solder sucker or a powered desoldering station with a heated hollow tip. You melt the solder in the plated-through hole and pull it out cleanly. This avoids scraping the plating, overheating the pad, or blowing molten solder around the board, so it is the preferred method.
Why the other answers are wrong
- A, Use a dental pick.: Prodding the hole with a dental pick can scratch or tear out the thin barrel plating that connects the board layers.
- C, Use a soldering iron tip that has a temperature above 900 degrees F.: An iron tip above 900 °F overheats the board. It can lift pads, delaminate the board, and damage the plating instead of removing solder cleanly.
- D, Use an air jet device.: An air jet blows molten solder across the board, where it can cause shorts. It also does not clear the hole reliably.