Element 3 Question 3-80L6
C3L80: Installation Codes & Procedures
What type of wire would connect an SSB automatic tuner to an insulated backstay?
- GTO-15 high-voltage cable. (correct answer)
- RG8U.
- RG213.
- 16-gauge two-conductor.
Correct answer: A, GTO-15 high-voltage cable.
Explanation
With an insulated backstay antenna, the automatic tuner sits near the base of the stay, and the lead from the tuner to the stay is part of the radiating antenna. That lead carries high RF voltage, often several thousand volts, so it needs heavily insulated single-conductor wire such as GTO-15. GTO-15 is neon-sign wire rated at 15 kV, and it resists flashover and leakage to the hull or rigging.
Why the other answers are wrong
- B, RG8U.: RG-8/U is coax for the low-impedance run from the transceiver to the tuner. A radiating high-voltage lead should not be coax, because the shield would stop it from radiating.
- C, RG213.: RG-213 is RG-8-class coax for the transceiver-to-tuner feed. It is not suited to the radiating high-voltage tuner-to-backstay lead.
- D, 16-gauge two-conductor.: Light two-conductor wire is for DC power or tuner control lines. Its thin insulation would arc over at the RF voltages found at the tuner output.