Element 3 Question 3-81L2
C3L81: Troubleshooting
The tachometer of a building’s elevator circuit experiences interference caused by the radio system nearby. What is a common potential “fix” for the problem?
- Replace the tachometer of the elevator.
- Add a .01 µF capacitor across the motor/tachometer leads. (correct answer)
- Add a 200 µF capacity across the motor/tachometer leads.
- Add an isolating resistor in series with the motor leads.
Correct answer: B, Add a .01 µF capacitor across the motor/tachometer leads.
Explanation
The motor/tachometer leads act as an antenna and pick up RF, so the usual cure is to bypass that RF to ground. A small 0.01 µF capacitor has very low reactance at radio frequencies, about Xc = 1/(2π·150 MHz·0.01 µF) ≈ 0.1 Ω. At the tachometer's low signal frequency, near 100 Hz, its reactance is roughly 160 kΩ. It shunts the RF and leaves the tach signal alone.
Why the other answers are wrong
- A, Replace the tachometer of the elevator.: The tachometer isn't faulty. The RF is picked up on its leads, so a new unit would show the same interference.
- C, Add a 200 µF capacity across the motor/tachometer leads.: 200 µF would load and distort the low-frequency tach signal, and a large electrolytic bypasses RF poorly because of its internal inductance.
- D, Add an isolating resistor in series with the motor leads.: A series resistor doesn't divert RF to ground. It only adds loss to the wanted circuit and leaves the interference in place.