Element 3 Question 3-86N3
C3N86: MF-HF, SSB-SITOR
What type of wire connects an SSB automatic tuner to an insulated backstay?
- RG8U.
- RG213.
- 16-gauge two-conductor.
- GTO-15 high-voltage cable. (correct answer)
Correct answer: D, GTO-15 high-voltage cable.
Explanation
The lead from an automatic tuner to an insulated backstay is part of the radiating antenna. At the high-impedance end of the antenna it can carry RF voltages of several thousand volts. It must therefore be a single heavily insulated conductor rated for high voltage, such as GTO-15 cable (rated about 15 kV). This keeps the RF from arcing to the deck or rigging.
Why the other answers are wrong
- A, RG8U.: RG-8U is coax for the radio-to-tuner run. Its grounded shield would load the antenna lead, and the lead must radiate, not be shielded.
- B, RG213.: RG-213 is also 50 Ω coax for feeding the tuner. Using it after the tuner would shunt the high-voltage antenna lead to ground through the shield.
- C, 16-gauge two-conductor.: 16-gauge two-conductor cable is the kind used for tuner power or control. Its thin insulation can't withstand kilovolt-level RF on the antenna lead.