Element 3 Question 3-93O6
C3O93: Antennas & Waveguides
To couple energy into and out of a waveguide use:
- Wide copper sheeting.
- A thin piece of wire as an antenna. (correct answer)
- An LC circuit.
- Capacitive coupling.
Correct answer: B, A thin piece of wire as an antenna.
Explanation
Energy enters or leaves a waveguide through a small probe, a short thin wire acting as a tiny antenna. It is usually about a quarter wavelength long and placed where the electric field is strongest. A small loop coupling to the magnetic field works too. The same principle runs in reverse: the probe radiates energy into the guide or picks it up from the fields inside.
Why the other answers are wrong
- A, Wide copper sheeting.: Wide copper sheeting forms the guide's walls, not a coupling element. A large conductor would short or block the fields rather than launch them.
- C, An LC circuit.: Lumped LC circuits work poorly at microwave frequencies. Waveguide energy is launched as fields by a probe or loop, not passed through a tank circuit.
- D, Capacitive coupling.: A discrete coupling capacitor is a technique for lower frequencies. Waveguide coupling is done by a probe or loop that excites the fields directly.