Element 1 Question 1-13C5
C1C13: VHF Equipment Controls
The “Scan” function is used to:
- Monitor Ch-16 continuously and switching to either Ch-70 or Ch-13 every 5 seconds.
- Scan Ch-16 for Distress calls.
- Scan Ch-70 for Distress alerts.
- Sequentially scan all or selected channels. (correct answer)
Correct answer: D, Sequentially scan all or selected channels.
Explanation
Scan steps the receiver through all channels or a programmed list. It pauses on any channel with a signal and moves on when that channel goes quiet. Many sets also check channel 16 as a priority channel during the scan. Scan is for following activity across channels. It does not replace the required channel 16 watch, and DSC alerts on channel 70 are caught by a dedicated DSC receiver.
Why the other answers are wrong
- A, Monitor Ch-16 continuously and switching to either Ch-70 or Ch-13 every 5 seconds.: This mixes up priority and tri-watch features. Channel 70 is DSC data, not voice, and scan isn't tied to any fixed channel pair or 5-second interval.
- B, Scan Ch-16 for Distress calls.: Watching channel 16 for distress calls is the job of continuous monitoring or dual watch. Scan sweeps many channels, not just 16.
- C, Scan Ch-70 for Distress alerts.: DSC alerts on channel 70 are decoded by a separate DSC watch receiver that never leaves channel 70. The voice scan function doesn't do this.