Element 1 Question 1-18C2
C1C18: Equipment Faults
Which would be an indication of proper operation of a SSB transmitter rated at 60 watt PEP output?
- In SSB (J3E) voice mode, with the transmitter keyed but without speaking into the microphone, power output is indicated.
- In SITOR communications, the power meter can be seen fluctuating regularly from zero to the 60 watt relative output reading. (correct answer)
- In SSB (J3E) mode, speaking into the microphone causes power meter to fluctuate slightly around the 60 watt reading.
- A steady indication of transmitted energy on an RF Power meter with no fluctuations when speaking into the microphone.
Correct answer: B, In SITOR communications, the power meter can be seen fluctuating regularly from zero to the 60 watt relative output reading.
Explanation
SITOR ARQ sends data in short bursts: the sending station transmits a three-character block at full output, then switches off to listen for the acknowledgment. A good 60 W transmitter therefore shows the meter swinging regularly between zero and the 60 W reading. In J3E there is no carrier, so output appears only when you speak.
Why the other answers are wrong
- A, In SSB (J3E) voice mode, with the transmitter keyed but without speaking into the microphone, power output is indicated.: J3E suppresses the carrier, so a keyed transmitter with a silent microphone should show almost no output. A reading there suggests carrier leakage or oscillation.
- C, In SSB (J3E) mode, speaking into the microphone causes power meter to fluctuate slightly around the 60 watt reading.: With J3E, speech should swing the meter from near zero up toward peak power. A meter that hovers around 60 W suggests a carrier or a fault, not normal SSB.
- D, A steady indication of transmitted energy on an RF Power meter with no fluctuations when speaking into the microphone.: A steady reading that doesn't change with speech means a carrier or a fault. Normal SSB output follows the voice, rising and falling as you talk.