Element 1 Question 1-18C6
C1C18: Equipment Faults
Which of the following conditions would be a symptom of malfunction in a 2182 kHz radiotelephone system that must be reported to the Master, then logged appropriately.
- Much higher noise level observed during daytime operation.
- No indication of power output when speaking into the microphone. (correct answer)
- When testing a radiotelephone alarm on 2182 kHz into an artificial antenna, the Distress frequency watch receiver becomes unmuted, an improper testing procedure.
- Failure to contact a shore station 600 nautical miles distant during daytime operation.
Correct answer: B, No indication of power output when speaking into the microphone.
Explanation
Under 47 CFR 80.268(a)(3), a 2182 kHz radiotelephone transmitter must show a visual indication whenever it is supplying power to the antenna. If that indicator shows no output while you speak into the microphone, the transmitter, microphone or antenna circuit has failed. That is a real equipment fault: report it to the Master and enter it in the log. The other choices describe normal propagation or a procedural mistake.
Why the other answers are wrong
- A, Much higher noise level observed during daytime operation.: Higher noise usually comes from atmospheric conditions or local interference, not a transmitter or receiver fault. Noise alone doesn't show the equipment has failed.
- C, When testing a radiotelephone alarm on 2182 kHz into an artificial antenna, the Distress frequency watch receiver becomes unmuted, an improper testing procedure.: This describes a mistake in how the test was done, not a broken radio. A receiver picking up the test signal shows it is working.
- D, Failure to contact a shore station 600 nautical miles distant during daytime operation.: In daytime, 2182 kHz is expected to reach only about 150 nautical miles by ground wave, so failing to work a station 600 nautical miles away is normal propagation.