Element 3 Question 3-20C3
C3C20: Capacitors
In Figure 3C4, which component (labeled 1 through 4) is used to provide a signal ground?

- 1
- 2 (correct answer)
- 3
- 4
Correct answer: B, 2
Explanation
Component 2 is the capacitor from the collector tank's center tap, where Vcc feeds in through a resistor, to ground. DC reaches the tank through the resistor, but at RF the capacitor's low reactance shorts any signal at that point to ground. That puts the tap at RF ground: it is a bypass, or decoupling, capacitor. It also keeps RF off the shared Vcc line, where it could couple into other stages.
Why the other answers are wrong
- A, 1: Point 1 is the base connection, fed by the input transformer. It carries the drive signal into the transistor, so it is a signal node, not ground.
- C, 3: Component 3 is the variable capacitor that tunes the collector tank to resonance. It sets the frequency rather than grounding the signal.
- D, 4: Component 4 is the collector tank coil, the primary of the output transformer, which couples the amplified signal to the next stage.