Element 3 Question 3-22C1
C3C22: Voltage Regulators, Zener Diodes
In a linear electronic voltage regulator:
- The output is a ramp voltage.
- The pass transistor switches from the “off” state to the “on”" state.
- The control device is switched on or off, with the duty cycle proportional to the line or load conditions.
- The conduction of a control element is varied in direct proportion to the line voltage or load current. (correct answer)
Correct answer: D, The conduction of a control element is varied in direct proportion to the line voltage or load current.
Explanation
A linear regulator works by continuously adjusting how hard a series pass transistor conducts. It acts like a variable resistance that changes with line voltage and load current, and absorbs the difference between input and output as heat. Because the pass element always operates in its active region and never switches, the output stays smooth and low-noise, at the cost of efficiency.
Why the other answers are wrong
- A, The output is a ramp voltage.: A ramp output describes a sawtooth or sweep generator, not a regulator, which aims for a steady DC output.
- B, The pass transistor switches from the “off” state to the “on”" state.: Switching between off and on states is how switching regulators work. A linear regulator's pass transistor conducts continuously.
- C, The control device is switched on or off, with the duty cycle proportional to the line or load conditions.: Varying the duty cycle of an on/off control device describes a switching (PWM) regulator, not a linear one.