Element 3 Question 3-46F1
C3F46: Filters and IF Amplifiers
What is the primary purpose of the final IF amplifier stage in a receiver?
- Dynamic response.
- Gain. (correct answer)
- Noise figure performance.
- Bypass undesired signals.
Correct answer: B, Gain.
Explanation
Selectivity is set early in the IF chain, usually by a crystal, ceramic or SAW filter right after the mixer. The later IF stages then supply most of the receiver's amplification. The final IF amplifier's main job is gain: raising the filtered signal to the level the detector needs, often with AGC control.
Why the other answers are wrong
- A, Dynamic response.: "Dynamic response" is not the defining job of any IF stage. The final stage exists to amplify the signal.
- C, Noise figure performance.: Noise figure is set mainly by the RF amplifier and mixer at the front end. Late IF stages handle strong signals and add little noise.
- D, Bypass undesired signals.: Rejecting undesired signals is the job of the IF filter early in the chain, not of the final amplifier stage.