Element 3 Question 3-46F4
C3F46: Filters and IF Amplifiers
What parameter must be selected when designing an audio filter using an op-amp?
- Bandpass characteristics. (correct answer)
- Desired current gain.
- Temperature coefficient.
- Output-offset overshoot.
Correct answer: A, Bandpass characteristics.
Explanation
An active filter exists to pass some audio frequencies and reject others. The first design choice is therefore its passband: center frequency, bandwidth (or Q) and the cutoff edges. Only then are the op-amp's resistor and capacitor values calculated, along with the circuit's voltage gain.
Why the other answers are wrong
- B, Desired current gain.: Op-amp filter stages are specified by voltage gain and frequency response. Current gain is not what sets which frequencies pass.
- C, Temperature coefficient.: Temperature stability depends on which components you pick. It is not the parameter that defines what an audio filter does.
- D, Output-offset overshoot.: "Output-offset overshoot" is not a filter design parameter. Offset voltage and overshoot are op-amp imperfections, not filter specifications.