Element 3 Question 3-50F6
C3F50: Receiver Performance
Pulse type interference to automobile radio receivers that appears related to the speed of the engine can often be reduced by:
- Installing resistances in series with spark plug wires. (correct answer)
- Using heavy conductors between the starting battery and the starting motor.
- Connecting resistances in series with the battery.
- Grounding the negative side of the battery.
Correct answer: A, Installing resistances in series with spark plug wires.
Explanation
Each spark-plug firing is a sharp current pulse that radiates broadband RF, so the clicks rise and fall with engine RPM. A resistance in series with each plug, such as resistor plugs or resistive ignition wire, limits the peak discharge current and damps the ringing. That cuts the radiated noise at its source. Bypass capacitors and shielding treat other noise sources, but series resistance is the standard fix for ignition noise.
Why the other answers are wrong
- B, Using heavy conductors between the starting battery and the starting motor.: Heavy starter cables reduce voltage drop while cranking, but the starter isn't running once the engine starts, so it can't cause noise that tracks engine speed.
- C, Connecting resistances in series with the battery.: A resistance in series with the battery would only starve the vehicle's electrical loads. It does nothing about the spark discharges radiating the pulse noise.
- D, Grounding the negative side of the battery.: Negative-ground wiring is just a polarity convention most vehicles already use. Which battery terminal is grounded doesn't suppress spark-generated RF.