Element 3 Question 3-76L1
C3L76: Oscilloscopes
What is used to decrease circuit loading when using an oscilloscope?
- Dual input amplifiers.
- 10:1 divider probe. (correct answer)
- Inductive probe.
- Resistive probe.
Correct answer: B, 10:1 divider probe.
Explanation
A 10:1 divider probe has a 9 MΩ resistor, shunted by a small compensating capacitor, in series with the scope's 1 MΩ input. The circuit under test then sees about 10 MΩ and much lower capacitance, so the probe draws less current and distorts the signal less. The trade-off is that the signal reaching the scope is cut to one tenth, which the operator must account for.
Why the other answers are wrong
- A, Dual input amplifiers.: Dual input amplifiers let the scope show two channels at once. They do nothing to raise the impedance the probe presents to the circuit.
- C, Inductive probe.: An inductive (current) probe senses the magnetic field around a conductor to measure current. It is not the standard way to reduce voltage-probe loading.
- D, Resistive probe.: A plain resistive probe without compensation would form an RC filter with the scope's input capacitance and distort fast signals. The compensated 10:1 divider is the accepted solution.