Element 3 Question 3-78L4
C3L78: Measurement Procedures
What is the common method for determining the exact sensitivity specification of a receiver?
- Measure the recovered audio for 12 dB of SINAD. (correct answer)
- Measure the recovered audio for 10 dB of quieting.
- Measure the recovered audio for 10 dB of SINAD.
- Measure the recovered audio for 25 dB of quieting.
Correct answer: A, Measure the recovered audio for 12 dB of SINAD.
Explanation
FM receiver sensitivity is stated as the RF input level, in µV, that gives 12 dB SINAD at the audio output. SINAD = (signal + noise + distortion) / (noise + distortion). A 12 dB ratio is about 4:1, so noise plus distortion make up about 25% of the audio, which is still usable speech. To measure it, lower the signal generator level until a SINAD meter reads 12 dB, then record that RF level.
Why the other answers are wrong
- B, Measure the recovered audio for 10 dB of quieting.: Quieting tests measure how far noise drops when a carrier arrives. That older method was usually quoted at 20 dB, and 10 dB of quieting is not the standard sensitivity reference.
- C, Measure the recovered audio for 10 dB of SINAD.: 10 dB SINAD is not the industry reference point. The accepted figure, used in TIA receiver standards, is 12 dB SINAD.
- D, Measure the recovered audio for 25 dB of quieting.: 25 dB of quieting is not a standard sensitivity point. Quieting does not account for distortion, which is why SINAD replaced it.