Element 3 Question 3-79L5
C3L79: Repair Procedures
A “hot gas bonder” is used:
- To apply solder to the iron tip while it is heating the component.
- For non-contact melting of solder. (correct answer)
- To allow soldering both sides of the PC board simultaneously.
- To cure LCA adhesives.
Correct answer: B, For non-contact melting of solder.
Explanation
A hot gas bonder directs a focused stream of heated air or gas onto a joint and melts the solder without any tip touching it. Non-contact heating is useful for surface-mount parts, closely spaced leads, and heat-sensitive components, because a soldering iron could damage or disturb them.
Why the other answers are wrong
- A, To apply solder to the iron tip while it is heating the component.: Feeding solder while heating is ordinary soldering-iron technique. It is not what a hot gas bonder does, and solder belongs on the joint, not the tip.
- C, To allow soldering both sides of the PC board simultaneously.: A hot gas bonder heats a localized spot. Soldering both sides of a board at once would take wave or reflow equipment.
- D, To cure LCA adhesives.: Adhesives such as light-cure types are cured with UV lamps or ovens. A hot gas bonder is a tool for melting solder.