Element 3 Question 3-79L6
C3L79: Repair Procedures
When repairing circuit board assemblies it is most important to:
- Use a dental pick to clear plated-through holes.
- Bridge broken copper traces with solder.
- Wear safety glasses. (correct answer)
- Use a holding fixture.
Correct answer: C, Wear safety glasses.
Explanation
Board repair throws things at your face. Clipped component leads fly off at speed, molten solder and flux can spatter, and solder-sucker and desoldering work can flick hot metal. Technique choices only affect the quality of the repair, but an eye injury can be permanent. Protecting your eyes with safety glasses therefore comes before any other consideration at the bench.
Why the other answers are wrong
- A, Use a dental pick to clear plated-through holes.: Picking at a plated-through hole can scrape off or lift the barrel plating. Holes are better cleared with heat and a solder sucker or braid, and this is technique, not the top priority.
- B, Bridge broken copper traces with solder.: A blob of solder across a break is a weak, poor-practice repair that can crack or overheat the trace. A proper repair uses a jumper wire or trace-repair strip, and it is still secondary to safety.
- D, Use a holding fixture.: A holding fixture steadies the board and makes the job easier, but it is a convenience. It matters less than protecting your eyes from flying leads and solder.