Element 3 Question 3-84M3
C3M84: Signal Processing, Software and Codes
Which statement best describes the code used for GMDSS-DSC transmissions?
- A 10 bit error correcting code starting with bits of data followed by a 3 bit error correcting code. (correct answer)
- A 10 bit error correcting code starting with a 3 bit error correcting code followed by 7 bits of data.
- An 8 bit code with 7 bits of data followed by a single parity bit.
- A 7 bit code that is transmitted twice for error correction.
Correct answer: A, A 10 bit error correcting code starting with bits of data followed by a 3 bit error correcting code.
Explanation
DSC (ITU-R M.493) sends each symbol as a 10-bit character. The first 7 bits carry the information, and the last 3 bits are a check field that counts the zeros in those 7 bits, so corrupted characters can be detected. DSC also sends each character twice, separated in time, for further error protection.
Why the other answers are wrong
- B, A 10 bit error correcting code starting with a 3 bit error correcting code followed by 7 bits of data.: This reverses the order: in a DSC character the 7 information bits come first and the 3-bit check field comes last.
- C, An 8 bit code with 7 bits of data followed by a single parity bit.: A 7-data-bit plus single parity bit layout describes ASCII-style parity, not the 10-bit DSC character.
- D, A 7 bit code that is transmitted twice for error correction.: DSC does repeat characters for time diversity, but each one is a 10-bit character with a 3-bit check field, not a bare 7-bit code.