Element 3 Question 3-84M4
C3M84: Signal Processing, Software and Codes
Which is the code used for SITOR-A and -B transmissions?
- The 5 bit baudot telex code.
- Each character consists of 7 bits with 3 “zeros” and 4 “ones”.
- Each character consists of 7 bits with 4 “zeros” and 3 “ones”. (correct answer)
- Each character has 7 bits of data and 3 bits for error correction.
Correct answer: C, Each character consists of 7 bits with 4 “zeros” and 3 “ones”.
Explanation
SITOR (ARQ mode A and FEC mode B) uses a 7-unit constant-ratio code. Every valid character has exactly 4 zeros and 3 ones. Any received character that breaks this 4:3 ratio must have been corrupted, so the receiver can detect it. It then asks for a repeat (ARQ) or uses the time-diversity copy (FEC). The ITA2 (Baudot) letters are mapped onto this 7-bit code for transmission.
Why the other answers are wrong
- A, The 5 bit baudot telex code.: The 5-bit Baudot (ITA2) alphabet is the source alphabet, but SITOR transmits each character as a 7-bit constant-ratio code, not as raw 5-bit Baudot.
- B, Each character consists of 7 bits with 3 “zeros” and 4 “ones”.: This inverts the ratio; SITOR characters have 4 zeros and 3 ones, not 3 zeros and 4 ones.
- D, Each character has 7 bits of data and 3 bits for error correction.: Seven data bits plus three check bits describes the 10-bit DSC character, not SITOR's 7-bit constant-ratio code.