Element 8 Question 8-10A1
C8A10: Circuits-2
In the circuit shown in Fig. 8A4, U5 pins 1 and 4 are high and both are in the reset state. Assume one clock cycle occurs of Clk A followed by one cycle of Clk B. What are the output states of the two D-type flip flops?
- Pin 5 low, Pin 9 low.
- Pin 5 high, Pin 9 low.
- Pin 5 low, Pin 9 high.
- Pin 5 high, Pin 9 high. (correct answer)
Correct answer: D, Pin 5 high, Pin 9 high.
Explanation
Both 74LS74 flip-flops start reset, so each Q is low and each Q-bar is high. With pins 1 and 4 high, the active-low clear and preset are inactive. The first flip-flop's D (pin 2) is tied to Q-bar (pin 6), which is high. The Clk A edge sets Q (pin 5) high. Pin 5 feeds the second flip-flop's D (pin 12), so the Clk B edge also clocks a high into Q (pin 9). Result: both outputs high.
Why the other answers are wrong
- A, Pin 5 low, Pin 9 low.: This assumes nothing changes when clocked. After reset, Q-bar is high, so the first flip-flop's D input is high and the clock edge sets its Q.
- B, Pin 5 high, Pin 9 low.: This forgets that pin 5 is the D input of the second flip-flop. Once pin 5 is high, the Clk B edge copies that high to pin 9.
- C, Pin 5 low, Pin 9 high.: Pin 5 can't stay low. The first flip-flop clocks in the high from its own Q-bar, and the second flip-flop then copies that high to pin 9.