Element 8 Question 8-21C1
C8C21: Local Oscillators
The error voltage from the discriminator is applied to the:
- Repeller (reflector) of the klystron. (correct answer)
- Grids of the IF amplifier.
- Grids of the RF amplifiers.
- Magnetron.
Correct answer: A, Repeller (reflector) of the klystron.
Explanation
In the AFC loop, a discriminator compares the actual IF with its design center frequency, such as 60 MHz. It outputs a DC error voltage whose polarity and size show the direction and amount of drift. A reflex klystron can be tuned electronically by its repeller (reflector) voltage. The error voltage is therefore added to the repeller supply, pulling the local oscillator back so the IF stays centered.
Why the other answers are wrong
- B, Grids of the IF amplifier.: The IF amplifier grids control gain, not frequency. Applying the error voltage there would change signal level without correcting the drift.
- C, Grids of the RF amplifiers.: A marine radar normally has no RF amplifier ahead of the mixer, and amplifier bias would not set the local oscillator frequency anyway.
- D, Magnetron.: The magnetron's frequency is left to drift. The AFC loop follows that drift by retuning the local oscillator, not the transmitter.