Element 8 Question 8-26C1
C8C26: Power Supplies
Prior to making “power-on” measurements on a switching power supply, you should be familiar with the supply because of the following:
- You need to know where the filter capacitors are so they can be discharged.
- If it does not use a line isolation transformer you may destroy the supply with grounded test equipment. (correct answer)
- It is not possible to cause a component failure by using ungrounded test equipment.
- So that measurements can be made without referring to the schematic.
Correct answer: B, If it does not use a line isolation transformer you may destroy the supply with grounded test equipment.
Explanation
Many switching supplies rectify the AC line directly, with no line isolation transformer, so the primary-side circuit common sits at line potential rather than at earth ground. If you clip the ground lead of a grounded oscilloscope or meter to that common, you short the line through the test-equipment ground. That fault current can destroy the supply and the instrument. Before taking live readings, find out whether the supply is isolated, or use an isolation transformer.
Why the other answers are wrong
- A, You need to know where the filter capacitors are so they can be discharged.: Discharging filter capacitors is a power-off safety step done before handling the circuit. It is not the hazard specific to taking power-on measurements with grounded equipment.
- C, It is not possible to cause a component failure by using ungrounded test equipment.: This statement is false. Test equipment, grounded or floating, can still load or short circuit nodes and cause failures. The question asks for a reason to be careful, not a reassurance.
- D, So that measurements can be made without referring to the schematic.: Familiarity with a supply doesn't replace the schematic. The real concern is whether the supply's common is tied to the AC line.