Element 8 Question 8-28C1
C8C28: Miscellaneous
The purpose of the discriminator circuit in a RADAR set is to:
- Discriminate against nearby objects.
- Discriminate against two objects with very similar bearings.
- Generate a corrective voltage for controlling the frequency of the klystron local oscillator. (correct answer)
- Demodulate or remove the intelligence from the FM signal.
Correct answer: C, Generate a corrective voltage for controlling the frequency of the klystron local oscillator.
Explanation
In a radar with a klystron local oscillator, AFC keeps the receiver tuned to the magnetron, whose frequency drifts with temperature and load. A sample of each transmitted pulse is mixed with the LO. The discriminator compares the resulting IF with its center frequency (e.g. 60 MHz) and outputs a positive or negative error voltage. That voltage retunes the klystron's reflector until the IF is centered.
Why the other answers are wrong
- A, Discriminate against nearby objects.: Suppressing nearby echoes is the job of sensitivity time control (STC, the sea clutter control), not a discriminator.
- B, Discriminate against two objects with very similar bearings.: Separating two targets on similar bearings depends on horizontal beamwidth (bearing resolution), not on a circuit.
- D, Demodulate or remove the intelligence from the FM signal.: That describes an FM receiver's detector. Radar echoes are pulses, and here the discriminator drives AFC rather than recovering audio.