Element 8 Question 8-28C3
C8C28: Miscellaneous
Where is a RF attenuator used in a RADAR unit?
- Between the antenna and the receiver.
- Between the magnetron and the antenna.
- Between the magnetron and the AFC section of the receiver. (correct answer)
- Between the AFC section and the klystron.
Correct answer: C, Between the magnetron and the AFC section of the receiver.
Explanation
The AFC circuit needs a sample of the transmitted pulse to measure the magnetron's frequency. The magnetron puts out kilowatts, but the AFC crystal mixer can handle only milliwatts. A directional coupler takes the sample from the waveguide, and an RF attenuator cuts it down to a safe level before it reaches the AFC mixer.
Why the other answers are wrong
- A, Between the antenna and the receiver.: An attenuator in the receive path would weaken already faint echoes. The receiver is protected by the TR cell, which fires only during transmit.
- B, Between the magnetron and the antenna.: The main waveguide run from magnetron to antenna must be as low-loss as possible. Attenuating it would waste transmitted power and range.
- D, Between the AFC section and the klystron.: The klystron is tuned by a DC correction voltage on its reflector, not by RF passed through an attenuator.