Element 8 Question 8-33D3
C8D33: Variable Range Markers
How is the variable range marker usually adjusted for accuracy?
- Adjusting the frequency of the VRM oscillator at the maximum range.
- Adjusting the frequency of the VRM oscillator at the minimum range.
- Adjusting the readout to match at the median range ring.
- The minimum and maximum ranges are aligned with the matching fixed range ring. (correct answer)
Correct answer: D, The minimum and maximum ranges are aligned with the matching fixed range ring.
Explanation
The VRM is calibrated against the fixed range rings, which are crystal-referenced and therefore trusted. The technician sets the VRM readout to a ring near the short end of the scale and adjusts until the VRM lies exactly on that ring. The same check is then made at a ring near the long end. Aligning both ends corrects zero (offset) and span, so the readout is accurate across the whole scale.
Why the other answers are wrong
- A, Adjusting the frequency of the VRM oscillator at the maximum range.: Adjusting only at maximum range sets the span but can leave an offset error at short ranges. Both ends must be aligned against the fixed rings.
- B, Adjusting the frequency of the VRM oscillator at the minimum range.: Adjusting only at minimum range corrects the offset but not the scale, so errors would grow toward long ranges.
- C, Adjusting the readout to match at the median range ring.: Matching one mid-scale ring cannot correct both offset and slope. The VRM could still be wrong near the ends of the scale.