Element 8 Question 8-50F6
C8F50: Safety
Prior to removing, servicing or making measurements on any solid state circuit boards from the RADAR set, the operator should ensure that:
- The proper work surfaces and ESD grounding straps are in place to prevent damage to the boards from electrostatic discharge. (correct answer)
- The waveguide is detached from the antenna to prevent radiation.
- The magnetic field is present to prevent over-current damage or overheating from occurring in the magnetron.
- Only non-conductive tools and devices are used.
Correct answer: A, The proper work surfaces and ESD grounding straps are in place to prevent damage to the boards from electrostatic discharge.
Explanation
Solid-state devices on radar boards, especially MOS and CMOS parts, can be destroyed or quietly weakened by static charges far too small for a person to feel. Before you pull, service or probe a board, set up a grounded static-dissipative work surface and wear a wrist strap tied to the same ground so charge drains off harmlessly. Keep boards in anti-static bags whenever they are out of the set.
Why the other answers are wrong
- B, The waveguide is detached from the antenna to prevent radiation.: Opening the waveguide does not make the set safe. If the transmitter is on, RF pours out of the open end. Radiation hazard is controlled by shutting down the transmitter, and it has nothing to do with board handling.
- C, The magnetic field is present to prevent over-current damage or overheating from occurring in the magnetron.: The magnetron's permanent magnet is always present and matters only to magnetron operation. It does nothing to protect circuit boards from static damage during servicing.
- D, Only non-conductive tools and devices are used.: Taking measurements requires conductive probes. ESD protection comes from grounding you and the work surface, not from banning conductive tools, and insulating tools can still carry static charge.