Amateur Extra Question E1A02
E1A: Frequency privileges; signal frequency range; automatic message forwarding; stations aboard ships or aircraft; power restriction on 630- and 2200-meter bands
When using a transceiver that displays the carrier frequency of phone signals, which of the following displayed frequencies represents the lowest frequency at which a properly adjusted LSB emission will be totally within the band?
- The exact lower band edge
- 300 Hz above the lower band edge
- 1 kHz above the lower band edge
- 3 kHz above the lower band edge (correct answer)
Correct answer: D, 3 kHz above the lower band edge
Explanation
On SSB the radio displays the suppressed-carrier frequency. A lower sideband signal lies entirely below that point, with voice energy extending about 3 kHz down. To keep the whole emission inside the band, as 97.307(b) requires, the displayed frequency must be at least 3 kHz above the lower edge. The same logic for USB near an upper edge puts the dial at least 3 kHz below that edge.
Why the other answers are wrong
- A, The exact lower band edge: At the exact edge, the entire LSB signal would sit below the band edge, which is the most out-of-band position possible.
- B, 300 Hz above the lower band edge: 300 Hz covers only the lowest voice frequencies; the rest of the roughly 3 kHz sideband would spill below the band edge.
- C, 1 kHz above the lower band edge: 1 kHz still leaves about 2 kHz of the lower sideband outside the band.