Amateur Extra Question E2E01
E2E: Operating methods: digital modes and procedures for HF
Which of the following types of modulation is used for data emissions below 30 MHz?
- DTMF tones modulating an FM signal
- FSK (correct answer)
- Pulse modulation
- Spread spectrum
Correct answer: B, FSK
Explanation
FSK, which shifts the carrier between two or more tones, is the classic HF data method. RTTY uses it, often as AFSK through an SSB transmitter, and FT8 and PACTOR I are FSK-based too. PSK and OFDM modes also run on HF but aren't among the choices. Section 97.305(c) authorizes spread spectrum only at 222 MHz and up and pulse only at 902 MHz and up, so neither may be used below 30 MHz.
Why the other answers are wrong
- A, DTMF tones modulating an FM signal: DTMF tones on FM are a repeater and remote-control signaling method at VHF/UHF, not an HF data mode; below 30 MHz, FM appears only in the upper part of 10 m.
- C, Pulse modulation: Section 97.305(c) authorizes pulse emissions only on bands at 902 MHz and above, so they cannot be used for data below 30 MHz.
- D, Spread spectrum: Section 97.305(c) authorizes spread spectrum only on 222 MHz and higher bands, so it is not available for data on HF.