Amateur Extra Question E4E01
E4E: Noise and interference: external RF interference; electrical and computer noise; line noise; DSP filtering and noise reduction; common-mode current; surge protectors; single point ground panel
What problem can occur when using an automatic notch filter (ANF) to remove interfering carriers while receiving CW signals?
- Removal of the CW signal as well as the interfering carrier (correct answer)
- Any nearby signal passing through the DSP system will overwhelm the desired signal
- Excessive ringing
- All these choices are correct
Correct answer: A, Removal of the CW signal as well as the interfering carrier
Explanation
An automatic notch filter finds steady, unvarying tones and nulls them out, because a heterodyne carrier is a constant tone. A CW signal is also a steady carrier tone while the key is down, so the ANF can mistake it for interference and notch out the very signal you want to copy. For this reason operators usually turn the ANF off for CW and use it mainly on voice modes.
Why the other answers are wrong
- B, Any nearby signal passing through the DSP system will overwhelm the desired signal: A nearby strong signal can cause overload or AGC pumping, but that is not a characteristic failure of the automatic notch feature.
- C, Excessive ringing: Ringing is associated with very narrow bandpass filters and aggressive noise reduction, not with an automatic notch removing a carrier.
- D, All these choices are correct: Only removal of the desired CW signal is the characteristic ANF problem. The overwhelming-signal and ringing statements do not apply, so not all choices are correct.