Amateur Extra Question E6F08
E6F: Electro-optical technology: photoconductivity; photovoltaic devices; optical sensors and encoders; optically isolated switching
Why are optoisolators often used in conjunction with solid-state circuits that control 120 VAC circuits?
- Optoisolators provide a low-impedance link between a control circuit and a power circuit
- Optoisolators provide impedance matching between the control circuit and power circuit
- Optoisolators provide an electrical isolation between a control circuit and the circuit being switched (correct answer)
- Optoisolators eliminate the effects of reflected light in the control circuit
Correct answer: C, Optoisolators provide an electrical isolation between a control circuit and the circuit being switched
Explanation
In an optoisolator the control signal crosses only as light, so there is no wired connection between the low-voltage control circuit and the 120 VAC side. This galvanic isolation keeps dangerous line voltage and transients out of the logic or radio circuitry and protects the operator. Typical isolation ratings run to thousands of volts.
Why the other answers are wrong
- A, Optoisolators provide a low-impedance link between a control circuit and a power circuit: The point is the opposite of a low-impedance link: the two circuits have essentially no electrical connection at all.
- B, Optoisolators provide impedance matching between the control circuit and power circuit: An optoisolator transfers an on/off signal optically; it does not match impedances between the two circuits.
- D, Optoisolators eliminate the effects of reflected light in the control circuit: The device is sealed and opaque, and stray reflected light is not the problem it solves; its purpose is electrical isolation.