Amateur Extra Question E8A10
E8A: Fourier analysis; RMS measurements; average RF power and peak envelope power (PEP); analog/digital conversion
What is the purpose of a low-pass filter used at the output of a digital-to-analog converter?
- Lower the input bandwidth to increase the effective resolution
- Improve accuracy by removing out-of-sequence codes from the input
- Remove spurious sampling artifacts from the output signal (correct answer)
- All these choices are correct
Correct answer: C, Remove spurious sampling artifacts from the output signal
Explanation
A DAC produces a stepped waveform that changes only at each sample clock. Those steps contain unwanted image frequencies around multiples of the sample rate, along with clock feedthrough. A low-pass reconstruction filter after the DAC removes these spurious sampling artifacts and leaves the smooth intended analog signal.
Why the other answers are wrong
- A, Lower the input bandwidth to increase the effective resolution: Limiting input bandwidth to improve resolution describes an anti-aliasing filter before an ADC, not a filter at a DAC output.
- B, Improve accuracy by removing out-of-sequence codes from the input: An analog output filter cannot inspect or remove digital codes at the converter's input; the phrase is a distractor.
- D, All these choices are correct: Only removing sampling artifacts is true; the other two statements describe things an output low-pass filter does not do.