Amateur Extra Question E8D01
E8D: Keying defects and overmodulation of digital signals; digital codes; spread spectrum
Why are received spread spectrum signals resistant to interference?
- Signals not using the spread spectrum algorithm are suppressed in the receiver (correct answer)
- The high power used by a spread spectrum transmitter keeps its signal from being easily overpowered
- Built-in error correction codes minimize interference
- If the receiver detects interference, it will signal the transmitter to change frequencies
Correct answer: A, Signals not using the spread spectrum algorithm are suppressed in the receiver
Explanation
A spread spectrum receiver uses the same pseudorandom code as the transmitter. Correlating with that code collapses the wanted signal back into a narrow band. Any signal without the code is spread across the wide bandwidth instead, so it ends up as low-level noise. This despreading process gives spread spectrum its built-in rejection of interference.
Why the other answers are wrong
- B, The high power used by a spread spectrum transmitter keeps its signal from being easily overpowered: Spread spectrum spreads its power thinly over a wide band, giving low power density, so it doesn't rely on high power to resist interference.
- C, Built-in error correction codes minimize interference: Error correction can be added to any digital mode, but the interference rejection comes from code correlation in the receiver, not from error correction.
- D, If the receiver detects interference, it will signal the transmitter to change frequencies: There is no feedback from the receiver: both ends follow a sequence fixed in advance rather than adapting to detected interference.