Amateur Extra Question E8D07
E8D: Keying defects and overmodulation of digital signals; digital codes; spread spectrum
What is a common cause of overmodulation of AFSK signals?
- Excessive numbers of retries
- Excessive frequency deviation
- Bit errors in the modem
- Excessive transmit audio levels (correct answer)
Correct answer: D, Excessive transmit audio levels
Explanation
AFSK sends audio tones into the transmitter's microphone or data input. If the audio level is set too high, the audio stages, ALC and amplifier are overdriven. The result is distortion, splatter and a signal wider than it should be. The cure is to reduce the audio drive until the ALC shows little or no action.
Why the other answers are wrong
- A, Excessive numbers of retries: Retries are a protocol's response to failed packets; they result from a poor signal and don't overmodulate the transmitter.
- B, Excessive frequency deviation: Overdeviation can be a symptom on FM rigs, but the root cause is still too much audio, and AFSK sent over SSB has no deviation to set.
- C, Bit errors in the modem: Bit errors show up at the receiving end as a result of a bad signal; they don't cause the transmitter to overmodulate.