Amateur Extra Question E9C10
E9C: Practical wire antennas; folded dipoles; phased arrays; effects of ground near antennas
Which of the following describes a Zepp antenna?
- A horizontal array capable of quickly changing the direction of maximum radiation by changing phasing lines
- An end-fed half-wavelength dipole (correct answer)
- An omni-directional antenna commonly used for satellite communications
- A vertical array capable of quickly changing the direction of maximum radiation by changing phasing lines
Correct answer: B, An end-fed half-wavelength dipole
Explanation
The Zepp, named for its use trailing from Zeppelin airships, is a half-wave wire fed at one end. The end of a half-wave radiator is a high-impedance, high-voltage point. The classic Zepp therefore uses open-wire feed line, often a quarter-wave matching section, rather than low-impedance coax connected directly.
Why the other answers are wrong
- A, A horizontal array capable of quickly changing the direction of maximum radiation by changing phasing lines: Switching direction with phasing lines describes a phased array, not a single end-fed wire.
- C, An omni-directional antenna commonly used for satellite communications: Satellite work usually uses circular polarization from turnstiles, helicals or crossed Yagis, not a Zepp.
- D, A vertical array capable of quickly changing the direction of maximum radiation by changing phasing lines: A vertical array steered by phasing lines is a phased vertical array, not an end-fed half-wave wire.