Amateur Extra Question E9E08
E9E: Impedance matching: matching antennas to feed lines; phasing lines; power dividers
What is a use for a Wilkinson divider?
- To divide the operating frequency of a transmitter signal so it can be used on a lower frequency band
- To feed high-impedance antennas from a low-impedance source
- To divide power equally between two 50-ohm loads while maintaining 50-ohm input impedance (correct answer)
- To divide the frequency of the input to a counter to increase its frequency range
Correct answer: C, To divide power equally between two 50-ohm loads while maintaining 50-ohm input impedance
Explanation
A Wilkinson divider splits RF power equally and in phase between two outputs while presenting a matched input. In a 50 Ω system it uses two quarter-wave 70.7 Ω line sections and a 100 Ω resistor between the outputs. The resistor isolates the two output ports from each other. Typical uses are feeding two antennas in a phased array, or combining amplifier outputs.
Why the other answers are wrong
- A, To divide the operating frequency of a transmitter signal so it can be used on a lower frequency band: A Wilkinson divider splits power, not frequency; both outputs carry the same frequency as the input.
- B, To feed high-impedance antennas from a low-impedance source: Feeding a high-impedance antenna from a low-impedance source needs a transformer or matching network, not an equal power splitter.
- D, To divide the frequency of the input to a counter to increase its frequency range: Extending a frequency counter's range uses a digital prescaler that divides frequency; the Wilkinson is a passive RF power splitter.