Amateur Extra Question E9F12
E9F: Transmission lines: characteristics of open and shorted feed lines; coax versus open wire; velocity factor; electrical length; coaxial cable dielectrics; microstrip
What impedance does a 1/4-wavelength transmission line present to an RF generator when the line is open at the far end?
- The same as the characteristic impedance of the line
- The same as the input impedance to the generator
- Very high impedance
- Very low impedance (correct answer)
Correct answer: D, Very low impedance
Explanation
A quarter-wave line inverts the load: Zin = Z0² / ZL. An open end makes ZL very large, so the input impedance becomes very low, close to a short circuit. The input sits at a current maximum and voltage minimum, so the line behaves like a series-resonant circuit. This is why open quarter-wave stubs can short out a single frequency.
Why the other answers are wrong
- A, The same as the characteristic impedance of the line: Z0 appears at the input only when the far end is terminated in a matching load, not when it is open.
- B, The same as the input impedance to the generator: A stub's input impedance is set by its length and end condition, not by any impedance inside the generator.
- C, Very high impedance: Very high impedance is what a shorted quarter-wave line presents; an open end inverts to a near-short.