Amateur Extra Question E9H06
E9H: Receiving antennas: radio direction finding (RDF) techniques; Beverage antennas; single- and multiple-turn loops
What indicates the correct value of terminating resistance for a Beverage antenna?
- Maximum feed point DC resistance at the center of the desired frequency range
- Minimum low-angle front-to-back ratio at the design frequency
- Maximum DC current in the terminating resistor
- Minimum variation in SWR over the desired frequency range (correct answer)
Correct answer: D, Minimum variation in SWR over the desired frequency range
Explanation
A Beverage is a long wire over ground that acts like a lossy transmission line. When the far-end resistor equals the line's characteristic impedance, nothing reflects back from the termination, so the feed point impedance stays nearly constant with frequency. You adjust the resistor until the SWR is flattest across the band you care about. That setting also gives the best front-to-back ratio.
Why the other answers are wrong
- A, Maximum feed point DC resistance at the center of the desired frequency range: DC resistance at the feed point says nothing about RF matching; the termination must match the wire's characteristic impedance at RF.
- B, Minimum low-angle front-to-back ratio at the design frequency: A correct termination maximizes front-to-back ratio, so seeking minimum front-to-back ratio would do the opposite.
- C, Maximum DC current in the terminating resistor: The antenna carries essentially no DC current, and the RF energy absorbed doesn't serve as an indicator of correct termination value.