General Question G2C01
G2C: CW operating procedures and procedural signals; Q signals; full break-in
Which of the following describes full break-in CW operation (QSK)?
- Breaking stations send the Morse code prosign “BK”
- Automatic keyers, instead of hand keys, are used to send Morse code
- An operator must activate a manual send/receive switch before and after every transmission
- Transmitting stations can receive between code characters and elements (correct answer)
Correct answer: D, Transmitting stations can receive between code characters and elements
Explanation
In full break-in (QSK) CW, the transmit/receive switching is fast enough that your receiver comes back on in the gaps between dots, dashes and characters. You hear the band while you send. The other station can interrupt you at any moment, and you'll hear it at once, which makes the exchange flow like a conversation.
Why the other answers are wrong
- A, Breaking stations send the Morse code prosign “BK”: BK is a prosign used to break in or turn the contact over quickly, but sending it is not what defines QSK; QSK is about receiving between elements.
- B, Automatic keyers, instead of hand keys, are used to send Morse code: Keyer type is irrelevant; QSK depends on rapid transmit/receive switching, and you can operate QSK with a hand key or a keyer.
- C, An operator must activate a manual send/receive switch before and after every transmission: A manual send/receive switch before and after each transmission is the opposite of break-in; QSK switches automatically and continuously.