General Question G2D03
G2D: Volunteer Monitor Program; HF operations
What procedure may be used by Volunteer Monitors to localize a station whose continuous carrier is holding a repeater on in their area?
- Compare vertical and horizontal signal strengths on the input frequency
- Compare beam headings on the repeater input from their home locations with that of other Volunteer Monitors (correct answer)
- Compare signal strengths between the input and output of the repeater
- All these choices are correct
Correct answer: B, Compare beam headings on the repeater input from their home locations with that of other Volunteer Monitors
Explanation
To find a station that is keying up a repeater, monitors listen on the repeater's input frequency, where the offending transmitter is heard directly. Each monitor turns a directional antenna toward the strongest signal and notes the bearing. Bearings plotted from several known locations cross near the transmitter. This method is called triangulation.
Why the other answers are wrong
- A, Compare vertical and horizontal signal strengths on the input frequency: Comparing vertical and horizontal strength shows the signal's polarization, which gives no direction or position for the transmitter.
- C, Compare signal strengths between the input and output of the repeater: The repeater output is the repeater's own transmitter, so comparing input and output strength tells you nothing about where the interfering station is.
- D, All these choices are correct: Only the beam-heading comparison locates a transmitter, since the polarization and input-versus-output comparisons cannot.