General Question G2E01
G2E: Digital mode operating procedures
Which mode is normally used when sending RTTY signals via AFSK with an SSB transmitter?
- USB
- DSB
- CW
- LSB (correct answer)
Correct answer: D, LSB
Explanation
In AFSK RTTY, audio tones (often 2125 Hz mark and 2295 Hz space) are fed into an SSB transmitter. LSB inverts the audio spectrum, so the higher-pitched space tone ends up lower in RF than the mark tone. That gives the same mark-high, space-low arrangement that direct FSK transmitters use. As a result, AFSK and FSK stations decode each other without any reversal.
Why the other answers are wrong
- A, USB: USB is the norm for most other sound-card digital modes, but for RTTY it inverts mark and space unless the tones are swapped, so LSB is the convention.
- B, DSB: Double sideband wastes power and spectrum by sending two copies of the audio; no RTTY convention uses DSB.
- C, CW: CW mode just keys a carrier on and off and does not pass audio tones from a sound card, so it cannot carry an AFSK signal.