General Question G2E04
G2E: Digital mode operating procedures
Which of the following is good practice when choosing a transmitting frequency to answer a station calling CQ using FT8?
- Always call on the station’s frequency
- Call on any frequency in the waterfall except the station’s frequency
- Find a clear frequency during the same time slot as the calling station
- Find a clear frequency during the alternate time slot to the calling station (correct answer)
Correct answer: D, Find a clear frequency during the alternate time slot to the calling station
Explanation
FT8 divides time into 15-second slots, and the two stations in a contact take turns. The calling station transmits in one slot (even or odd), so you must reply in the other slot, when it is listening. Its software decodes the whole passband, so you can pick any clear frequency. A clear spot avoids colliding with other callers and with the CQing station's own signal.
Why the other answers are wrong
- A, Always call on the station’s frequency: Everyone piling onto the CQ frequency causes collisions; the receiving software decodes the whole passband, so a clear spot works better.
- B, Call on any frequency in the waterfall except the station’s frequency: Avoiding the station's frequency is fine, but this ignores timing; transmitting in the same slot as the caller means it never hears you.
- C, Find a clear frequency during the same time slot as the calling station: In the same time slot the calling station is transmitting rather than receiving, so it cannot decode your reply.