General Question G2E07
G2E: Digital mode operating procedures
Which of the following is required when using FT8?
- A special hardware modem
- Computer time accurate to within approximately 1 second (correct answer)
- Receiver attenuator set to -12 dB
- A vertically polarized antenna
Correct answer: B, Computer time accurate to within approximately 1 second
Explanation
FT8 runs in fixed 15-second transmit and receive periods that start on the clock, so both stations must agree on the time. If your computer clock is off by more than about 1 second, decoding fails or your signal lands outside the other station's receive window. Most operators sync to an internet time server or a GPS receiver.
Why the other answers are wrong
- A, A special hardware modem: FT8 needs no special hardware modem: software such as WSJT-X handles encoding and decoding through an ordinary sound card or radio audio interface.
- C, Receiver attenuator set to -12 dB: No particular attenuator setting is required; you only need to keep receive audio at a sensible level so the decoder isn't overloaded.
- D, A vertically polarized antenna: FT8 works with any antenna polarization; horizontal dipoles, beams and verticals are all used, especially since HF sky-wave scrambles polarization.